Report Inspector - Geometry

From Report Inspector, you can change the geometrical properties of your shapes.  Typically when we deal with coordinates, each section is a separate quadrant.  The x coordinate goes from left (0) to right (720) and the y coordinate goes from top (0) to bottom (unlimited). 

• X: This property shows the horizontal coordinate for a field or object in a specific section.  If you adjust the number, the object will move horizontally across the section.
  
  
• Y: This property shows the vertical coordinate for a field or object in a specific section.  If you adjust the number, the object will move vertically across the section.
  
  
• Width: You can adjust the width of a field, object, or section in this area.
  
  
• Height: You can adjust the height of a field, object, or section in this area.
  
  
• Top Attach Pos X: Changing this number will drag the upper handle horizontally across the section, thus increasing or decreasing its shape. 
  
  

  This object's value in Top Attach Pos X was 125

  When we changed it to 0, the object's upper handle moved to the coordinate 0 thus expanding the object's area.

• Top Attach Pos Y: Changing this number will drag the upper handle vertically across the section.
  
  

  This object's value in Top Attach Pos Y was 50

  When we changed it to 100, the object's upper handle moved to the coordinate100 thus decreasing the object's area.

• Bottom Attach Pos X: Changing this value will drag the bottom handle horizontally across the section.
  
  
• Bottom Attach Pos Y: Changing this value will drag the bottom handle horizontally across the section.